Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Arleta, CA
Chimney repair in Arleta usually means one of two things: a flue that’s been ignored since the house was built, or a gas insert conversion that was done years ago and never inspected. Most homes here went up in the 1950s and 60s with original brick masonry fireplaces, and because Valley winters are mild, those fireplaces sit unused for years at a time. The work we do most often in ZIP 91331 is chasing down what that idle time causes: hardened creosote, cracked firebox mortar, rusted dampers, and bird or rodent nests packed into uncapped flues. If you need a sweep, an inspection, or a liner repair, call (877) 939-1446 and we’ll schedule a time that works.
Why Arleta Homes Are Different
Arleta is a postwar San Fernando Valley tract-home neighborhood, dense rows of single-story stucco houses on small lots, most built between 1950 and 1965. That era of construction came with real brick masonry fireplaces, often as the centerpiece of the living room. Six or seven decades later, those fireboxes and flues are original equipment in most cases. What makes Arleta different from a mountain community is the usage pattern. Fireplaces here are lit a handful of times a year at most, and many haven’t been used in a decade. The owner assumes that means the chimney is fine. In reality, the opposite is often true. Creosote from the last fire sits and hardens, mortar dries and crumbles, and uncapped flues collect dust, leaves, and nesting material from birds and rodents. Santa Ana winds push fine Valley dust into every gap. When a homeowner finally decides to light a fire, the system has been degrading silently for years. The local norm is a cold chimney that hasn’t been swept in ten years, not one that’s been overused.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Arleta Services
Most Arleta homeowners call us for one of two reasons: they want the fireplace cleaned and inspected before using it, or they’re concerned about the dryer vent. Both are fire-safety systems, and both are easy to ignore until something goes wrong.
Chimney Sweep in Arleta
A sweep in Arleta often starts with clearing out what’s accumulated during years of no use. We remove creosote, soot, and debris, then run a camera inspection so you can see the flue condition with your own eyes. The combination of occasional fires, long idle stretches, and Santa Ana dust means Arleta flues often have baked-on creosote that takes more than a quick brush pass. We check the damper, the firebox, and the cap, and we tell you plainly whether anything needs repair or whether the chimney is safe to use as-is. See the full breakdown on our Chimney Sweep in Arleta page.
Dryer Vent Cleaning in Arleta
Dryer vents in tight 1950s and 60s tract homes are often short runs, but they’re rarely cleaned. Lint builds up behind the dryer and inside the duct, restricting airflow and turning the dryer into a fire hazard every cycle. We clean the full vent run from the dryer to the outside termination, verify the cap opens and closes properly, and check for the crushed or disconnected sections we commonly find in older Arleta laundry rooms. Read more on the dedicated Dryer Vent Cleaning in Arleta page.
Chimney Repair in Arleta
Chimney repair in Arleta is typically about deferred maintenance catching up. The houses are from the 1950s and 60s, the fireplaces are original, and the mild climate means problems have had decades to develop quietly. Cracked firebox mortar, missing or rusted caps, failed flashing, and deteriorated liners are what we see most often. When you call, we inspect first, show you the camera footage, and only recommend work that the evidence supports. If the problem is the liner, we can resurface or reline it using HeatShield or DuraFlex systems, which most sweep-only companies don’t offer. This is the repair side of what we do; see Chimney Repair for the full service overview.
Chimney Cap Installation
Signs you need it
You find bird droppings, nesting material, or debris inside the firebox, or you can see from the ground that the flue opening is uncovered.
What it costs in Arleta
A standard cap installation in Arleta typically runs from $280 to $520, depending on flue size and whether the chase cover or mounting surface needs work first.
How we do it
We measure the flue, confirm the tile or liner condition, secure the cap to the crown with proper fasteners, and verify the termination is correct for your appliance type.
Chimney Liner Installation
Signs you need it
You see flaking tile pieces in the firebox, the chimney fails a camera inspection, or an old gas insert was installed without a properly sized liner.
What it costs in Arleta
Liner installation in Arleta typically ranges from $3,400 to $6,400, depending on flue length, liner material, and whether the old liner comes out in one piece.
How we do it
We inspect the existing flue, recommend either HeatShield resurfacing or a DuraFlex liner, and install the system to meet the appliance’s venting requirements.
Chimney Crown Repair
Signs you need it
Water is staining the walls or ceiling near the chimney, or the concrete crown shows visible cracks, spalling, or missing sections.
What it costs in Arleta
Crown repair in Arleta usually runs from $500 to $1,300, with the final price depending on the damage and whether the crown needs a full rebuild.
How we do it
We clean and prep the crown surface, fill cracks with the right sealant, and apply a proper crown coat that sheds water away from the flue.
What Chimney Repair Costs in Arleta
| Item | Typical range in Arleta |
|---|---|
| Chimney cap installation | $280 – $520 |
| Chimney crown repair | $500 – $1,300 |
| Chimney liner installation | $3,400 – $6,400 |
Do I need a new liner or can the old one be fixed?
That depends on the camera inspection. If the flue tiles have minor gaps, HeatShield resurfacing can often restore the liner without a full replacement. If the tiles are collapsed or the clay is gone, a DuraFlex liner is the safer route. We’ll show you the footage before recommending either.
Can you match the existing brick or roof flashing color?
Yes. Caps are available in stainless, copper, and black finishes, and we can match the flashing metal to your roof color. If you have a specific tone in mind, mention it when you call (877) 939-1446 and we’ll bring the right options.
Brands We Service in Arleta
We stock and install the brands professional chimney technicians rely on, including HeatShield for liner resurfacing, Olympia Chimney accessories, and Famco terminations. Parts are kept on hand for common Arleta repairs, so cap and termination work usually doesn’t require a second visit. See our brands for details on what we carry.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Arleta, CA
| Service | Typical range in Arleta |
|---|---|
| Chimney sweep (standard) | $180 – $320 |
| Chimney cap installation | $280 – $520 |
| Chimney cap replacement | $320 – $560 |
| Chimney crown repair | $500 – $1,300 |
| Chimney flashing repair | $380 – $780 |
| Chimney liner installation | $3,400 – $6,400 |
| Dryer vent cleaning | $130 – $260 |
What pushes prices up in Arleta is access. Original 1950s and 60s rooflines are steep in places, and years of Santa Ana sun can make flashing and crowns brittle, which means more prep time. Every job is priced upfront, with a flat quote agreed before we start, so there’s no surprise at the end.
Neighborhoods We Serve in Arleta
We work throughout Arleta and the 91331 ZIP code, from the blocks east of Woodman Avenue to the homes near Branford Park and the neighborhoods around Vena Avenue Elementary. Our typical response time for scheduling in Arleta is within a few business days, depending on the season.
- Branford Park area
- Woodman Avenue corridor
- Beachy Avenue blocks
- Arleta Avenue neighborhood
- Vena Avenue Elementary district
Service Area – Cities Near Arleta
Chimney Sweep Winnetka serves Arleta and the surrounding San Fernando Valley communities. If you’re in Pacoima, CA, Mission Hills, CA, Panorama City, CA, or North Hills East, CA, we can schedule the same chimney, dryer vent, and repair services. Call (877) 939-1446 to confirm your address is in our service area.
Serving Arleta, CA – Our Local Coverage Area
We’re based in the Arleta area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Arleta
Most Arleta appointments are scheduled within a few business days, depending on service type and season. If you have an active leak or visible damage, mention it when you call (877) 939-1446 and we’ll prioritize the visit.
Most routine sweeps, cap replacements, and liner work don’t require a city permit. If a repair touches structural framing or requires roofing work beyond standard flashing, we’ll tell you during the estimate. We never file permits on your behalf unless it’s part of the agreed scope.
Yes. We clean and inspect wood-burning masonry fireplaces and also service gas inserts that were added to original Arleta fireplaces. Many local homes have converted gas units, and those flues still need regular cleaning and inspection, especially if the original liner is still in place.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Arleta Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Greg Kowalski"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
- Jennifer Ackerman"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
- Hector Guzman